R&S NRP2 - Service

Remote Control - Commands
R&S
®
NRP2
290User Manual 1173.9157.02 ─ 03
Parameters:
int_value
Range: depending on sensor
*RST: depending on sensor
[SENSe<[1]..4>]:TRACe:REALtime <state>
In the default state (OFF), each measurement from the sensor is averaged. With
[SENSe<[1]..4>]:TRACe::REALtime ON , this behaviour can be switched off, which
may increase the measurement speed. With a higher measurement speed the measured
values of an individual measurement are immediately delivered.
Parameters:
<state> ON | OFF
*RST: depending on sensor
[
SENSe<[1]..4>]:TRACe:TIME <time>
Sets the time to be covered by the Trace sequence.
Parameters:
<time> float_value
Range: depending on sensor
*RST: depending on sensor
Default unit: S
[SENSe<[1]..4>]:V2P?
Usage:
Query only
6.12 SERVice
The commands of the SERVice system are used for maintenance or test purposes. They
were implemented primarily to support device development. The numeric suffix refers to
the sensors.
Before commands of the SERVice system can be sent to a sensor, they must be enabled
via the SERVice:UNLock 1234 command.
SERVice<[1]..4>:CALibration:TEST?...............................................................................291
SERVice<[1]..4>:CALibration:TEMP.................................................................................291
SERVice<[1]..4>:CALibration:TEMP:DATA?.....................................................................291
SERVice:DISPlay:OVERload..........................................................................................291
SERVice<[1]..4>:RCOunt................................................................................................292
SERVice