R&S NRP2 - Calculate (Configuration of Calculate Blocks)

Remote Control - Commands
R&S
®
NRP2
221User Manual 1173.9157.02 ─ 03
MEASurement<[1]..8>[:SCALar][:POWer]:BURSt
MEASurement<[1]..8>[:SCALar][:POWer]:BURSt:RELative
MEASurement<[1]..8>[:SCALar][:POWer]:BURSt:DIFFerence
MEASurement<[1]..8>[:SCALar][:POWer]:BURSt:DIFFerence:RELative
MEASurement<[1]..8>[:SCALar][:POWer]:BURSt:SUM
MEASurement<[1]..8>[:SCALar][:POWer]:BURSt:SUM:RELative
MEASurement<[1]..8>[:SCALar][:POWer]:BURSt:RATio
MEASurement<[1]..8>[:SCALar][:POWer]:BURSt:RATio:RELative
MEASurement<[1]..8>[:SCALar][:POWer]:BURSt:SWR
MEASurement<[1]..8>[:SCALar][:POWer]:BURSt:REFLection
MEASurement<[1]..8>[:SCALar][:POWer]:BURSt:RLOSs <dtolerance>,
<start_exclude>, <end_exclude>, [<expected_value> [,<resolution>]]
[,<source_list>]
MEASurement commands for measurement mode Burst.
MEASurement<[1]..8>:ARRay[:POWer][:AVG]
MEASurement<[1]..8>:ARRay[:POWer][:AVG]:RELative
MEASurement<[1]..8>:ARRay[:POWer][:AVG]:DIFFerence
MEASurement<[1]..8>:ARRay[:POWer][:AVG]:DIFFerence:RELative
MEASurement<[1]..8>:ARRay[:POWer][:AVG]:SUM
MEASurement<[1]..8>:ARRay[:POWer][:AVG]:SUM:RELative
MEASurement<[1]..8>:ARRay[:POWer][:AVG]:RATio
MEASurement<[1]..8>:ARRay[:POWer][:AVG]:RATio:RELative
MEASurement<[1]..8>:ARRay[:POWer][:AVG]:SWR
MEASurement<[1]..8>:ARRay[:POWer][:AVG]:REFLection
MEASurement<[1]..8>:ARRay[:POWer][:AVG]:RLOSs (<buffered_size>),
[<expected_value>[,<resolution>]] [,<source_list>]
MEASurement commands for measurement mode ContAv with buffering.
MEASurement<[1]..8>:XTIMe[:POWer]
MEASurement<[1]..8>:XTIMe[:POWer]:RATio (<scope_size>), <capture_time>
[,<source_list>]
MEASurement commands for measurement mode Trace.
MEASurement<[1]..8>:STATistics:CCDF
MEASurement<[1]..8>:STATistics:PDF (<statistics_size>), <capture_time>
[,<source_list>]
MEASurement commands for measurement mode Statistics.
6.5 CALCulate (Configuration of Calculate Blocks)
The calculate blocks calculating the measurement results from the sensor data are con-
figured with the CALCulate command. Eight blocks are available, each with two input
CALCulate (Configuration of Calculate Blocks)