R&S NRP2 - A Remote Control Interfaces; GPIB Bus Interface

Remote control interfaces
R&S
®
NRP2
349User Manual 1173.9157.02 ─ 03
A Remote control interfaces
This section covers hardware related topics on the remote control interfaces, like pin
assignment of the GPIB bus interface.
For information on how to set up a remote control connection via the different interfaces,
see chapter 5.2, "Connecting a Controller to the Base Unit", on page 168.
For information on how to configure the interfaces, see chapter 4.7.1, "Configuring the
remote control interfaces", on page 143.
All other hardware interfaces are described in chapter 1.6, "Rear Panel", on page 15
For specifications refer to the data sheet.
A.1 GPIB Bus Interface
A.1.1 Characteristics of the interface
●
8-bit parallel data transmission
●
Bidirectional data transmission
●
Three-wire handshake
●
Data transmission rate up to 350 Kbyte/s
●
Connection of up to 15 devices
●
Max. length of connecting cables: 15 m (length of single cable: 2 m)
●
Wired OR links when several devices are connected in parallel.
GPIB Bus Interface