R&S NRP2 - Unit

Remote Control - Commands
R&S
®
NRP2
331User Manual 1173.9157.02 ─ 03
Parameters:
<state> BUS | EXTernal | HOLD | IMMediate | INTernal
BUS
The trigger event is initiated by TRIG:IMM or *TRG. In this case,
the other trigger setting are meaningless.
EXTernal
Triggering is performed with an external signal applied to the trig-
ger connector. The TRIG:SLOP command determines whether
the rising or the falling edge of the signal is to be used for trigger-
ing. Waiting for a trigger event can be skipped by TRIG:IMM.
HOLD
A measurement can only be triggered when the command
TRIG:IMM is executed.
IMMediate
The sensor does not remain in the WAIT_FOR_TRG state but
immediately changes to the MEASURING state.
INTernal
The sensor determines the trigger time by means of the signal to
be measured. When this signal exceeds (TRIG:SLOP POS) or fall
short of (TRIG:SLOP NEG) the power set by TRIG:LEV, the mea-
surement is started after the time set by TRIG:DEL. Similar to
TRIG:SOUR EXT, waiting for a trigger event can also be skipped
by TRIG:IMM.
*RST:
depending on sensor
TRIGger<[1]..4>:SYNChronize[:STATe] <state>
If set to ON, the command blocks the external trigger bus as long as the sensor is not in
WAIT_FOR_TRIGGER state. It is usually used in combination with command 
TRIG:MAST and makes certain, that a new measurement will only be started after all
sensors have completed their last measurement.
Parameters:
<state> ON | OFF
*RST: depending on sensor
6.16 UNIT
Commands of the UNIT system
UNIT<[1]..8>:POWer......................................................................................................331
UNIT<[1]..8>:POWer:RATio............................................................................................332
UNIT<[1]..8>:POWer <output_unit>
Selects the output unit for the measured power values.
UNIT