R&S NRP2 - Page 266

Remote Control - Commands
R&S
®
NRP2
248User Manual 1173.9157.02 ─ 03
MEMory:TABLe:DATA:POINts?.......................................................................................251
MEMory:TABLe:FREQuency...........................................................................................251
MEMory:TABLe:FREQuency:POINts?..............................................................................251
MEMory:TABLe:GAIN[:MAGNitude].................................................................................251
MEMory:TABLe:GAIN:POINts?.......................................................................................252
MEMory:TABLe:MAP.....................................................................................................252
MEMory:TABLe:MOVE...................................................................................................252
MEMory:TABLe:RESet...................................................................................................252
MEMory:TABLe:SELect..................................................................................................252
MEMory:CATalog[:ALL]?
Lists the names of all stored device states and correction tables. The length of the
response depends on how many device states and tables are stored.
Return values:
<NR1>, <NR1>
{,"<string>"}
The first two values denote the length in bytes of the occupied
RAM and of the RAM still available for storing states and tables.
These values are followed by a string for each stored state and
then for each stored table; this string again consists of two strings
and a numeric value:
<string>, <type>, <NR1>
<string> gives the name of the stored data item, <type> the type
(TABL or STAT) and <NR1> the length of the data item in bytes.
Example: The response to query MEM:CAT? could be:
956,99044,"REFL,STAT,408","NRPZ21,TABL,
432","SPLITTER1,TABL,116"
Usage: Query only
MEMory:CATalog:STATe?
Only gives a list of stored device states and is otherwise identical with
MEMory:CATalog[:ALL]?.
Usage:
Query only
MEMory:CATalog:TABLe?
Only gives a list of stored correction tables and is otherwise identical with
MEMory:CATalog[:ALL]?.
Usage:
Query only
MEMory:CLEar[:NAME] <name>
Clears the content of the correction table or the stored device state with the designation
<name>. The table is maintained but does not contain entries.
Notice: Possible data loss
MEMory