Manual No. 016-3001-015 Rev. C 271
5. Touch the node update to apply.
Up to five single product nodes may be used in some applications. If more than one node is on the system,
the node selection buttons will be displayed below the update list.
6. To start the node update:
a. If a non-product node (i.e. Raven Switch Box, Drill Cart) is selected, touch the Start button in the lower
right corner of the screen to begin the update.
b. For single product control nodes, select the Node button corresponding to the product node to update.
c. For product controller nodes, select the first available node channel to which the controller node is
assigned.
Note: If the Viper Pro cannot communicate with the selected node, the CAN Update Program will display
an error. Troubleshoot the node and retry the update.
7. The Viper Pro begins communicating with the selected update. If communication is successful, the Viper
Pro will begin the update by erasing the node’s memory.
Note: The Viper Pro may take several minutes to prepare and apply the software update to the node.
8. When the update is completed, Viper Pro will display a Programming Complete prompt. Touch the OK
button to continue.
Note: If errors are encountered during the node update re-apply the node update.
9. To update other nodes via the Viper Pro CANbus repeat step 5 through 8.
To Next Page
Loading...
