Manual No. 016-3001-015 Rev. C 287
2. Touch the “Registration Code” button to register the device on the Slingshot site.
3. A registration code will automatically be sent to the Slingshot site. After Slingshot receives the code, the
device is registered.
www.ravenslingshot.com
Note: Be sure to enable the Remote Service and Web Access features if desired (recommended). These
features may be enabled later by accessing the Slingshot site.
To test wireless access:
1. Wait for the Viper Pro to automatically search for available files for transfer. This process may take up to five
minutes.
2. If the Remote Service feature was enabled during registration, select the Remote Service tab and touch the
“Enable Remote Service” button.
3. If a remote service session is enabled successfully, touch the button now labeled “Disable Remote Service.”
4. Exit the Wireless Status screen by touching the OK button in the lower, right corner of the screen.
5. If the Web Access feature was enabled during registration, touch Menu > Web to open the Viper Pro
internet browser and test the web access feature.
To Next Page
Loading...
