4
Manual No. 016-3001-015 Rev. C 31
Initial Set Up and Navigation
Disable Control Channels. Initially, the air cart node is configured to provide five control channels for the
OmniSeed system. It is recommended to remove control channels to configure the node for the maximum
number of bins used with the air seeder system or to make control channels available for a product controller
node to control liquid product application with the OmniSeed system.
To remove control channels from the air cart node:
1. From the CAN Initialization Results prompt, select the Start Viper option and allow the Viper Pro application
to initialize.
Note: Even if the product controller node is connected to the CANbus network during the initial start up
of the OmniSeed system, all product control channels displayed on the CAN Initialization Results
screen are assigned to the air cart node.
2. From the Viper Pro main screen, touch the Product Control button in the lower, left corner of the Viper Pro
display.
To Next Page
Loading...
