Chapter 4
36 OmniSeed™ Viper Pro™ Installation & Operation Manual
6. Touch the Finish button to finish re-addressing nodes on the CANbus. The Viper Pro will re-initialize the
CANbus system using the new node addresses and display the CAN Initialization Results screen.
The “AccuBoom Node” entry indicates that the field computer has recognized the product controller node.
7. Touch the Config. Node button to reconfigure the number of control channels available on the product
controller node.
8. Touch Start Viper when the appropriate number of control channels are displayed as ‘Found’ on the CAN
Initialization Results screen.
To Next Page
Loading...
