4
Manual No. 016-3001-015 Rev. C 45
Initial Set Up and Navigation
The CAN Controller Status screen will display.
3. Select the desired product bin to calibrate the corresponding sensor. If multiple bin pressure sensors are
installed on a multi-bin air cart, the following steps will need to be repeated to calibrate each sensor
individually.
4. Touch the Fan Calibration area to access the Fan Calibration screen.
The system offers five bin pressure monitoring channels for use with seeder control systems.
Note: The AUX channel may be used as a sixth bin pressure channel if necessary. Select the type of
sensor (Air/Liquid) for bin pressure monitoring and set the values as described below.
To Next Page
Loading...
