4
Manual No. 016-3001-015 Rev. C 55
Initial Set Up and Navigation
Tracked Tractor
Note: The pivot point of a tracked tractor is in the center of the track length on the center-line of the
vehicle.
1. Enter the left/right offset of the GPS antenna from the pivot point. The left/right offset must be measured
perpendicular to the direction of forward travel.
2. To determine the offset direction, at the pivot point and facing toward the front of the vehicle, is the antenna
to the left or to the right? Select the direction of the left/right offset.
3. Enter the fore/aft offset of the GPS antenna from the pivot point. The fore/aft offset must be measured
parallel to the direction of forward travel.
4. To determine the offset direction, at the pivot point and facing toward the front of the vehicle, is the antenna
in front (fore) or behind (aft) of the pivot position? Select the direction of the fore/aft offset.
5. Measure the distance from the pivot point (center of track length) to the control point or hitch.
6. Touch the Next button and continue to the Cart Setup section on page 56 or the Drill Setup section on
page 57.
Articulated Tractor
Note: The pivot point of an articulated tractor is center of the articulation joint.
1. Enter the left/right offset of the GPS antenna from the pivot point. The left/right offset must be measured
perpendicular to the direction of forward travel.
2. To determine the offset direction, at the pivot point and facing toward the front of the vehicle, is the antenna
to the left or to the right? Select the direction of the left/right offset.
3. Enter the fore/aft offset of the GPS antenna from the pivot point. The fore/aft offset must be measured
parallel to the direction of forward travel.
GPS Antenna Fore/Aft
Measurement
GPS Antenna Left/
Right Measurement
Pivot/Control Point
Distance
GPS Antenna Fore/Aft
Measurement
GPS Antenna Left/
Right Measurement
Pivot/Control Point
Distance
Rear Axle Offset
Front Axle Offset
To Next Page
Loading...
