Chapter 4
80 OmniSeed™ Viper Pro™ Installation & Operation Manual
Product Control Status Display
The Product Control Status of the CAN system is displayed in this area.
The status indicator displays red if communication with the CANbus system is not available. The status area
will display in yellow symbol if the Viper Pro detects a problem with the CANbus system such as an alarm
condition. The status indicator will display in green during normal operation.
Touch the Product Control Status or indicator to view the CAN Controller Status screen and access the Node
Setup screens when connected to a Raven CANbus system.
Note: See the Controller Status Screen section on page 84 for an overview of the settings and
information areas displayed on the CAN Controller Status screen. Review Chapter 7, Advanced
Settings and Features, for more information on the Product Control status and using the CAN
Controller Status screens on the Viper Pro field computer.
SmarTrax Status Area and Steering Indicator
If an optional SmarTrax system is installed with the Viper Pro, the status of the system will be displayed in this
area.
If the SmarTrax system is engaged, the steering indicator will display a green steering wheel with the ‘A’ as
shown above. When the SmarTrax system is disengaged, the steering wheel will be grey and no A will appear.
Note: Refer to the SmarTrax Calibration and Operation Manual for additional information.
To Next Page
Loading...
