Precautions
139
9
Banner page
You should not configure a banner
page on NetWare. If you want to
change the banner page setting, al-
ways configure it using Windows.
• Under Windows 95/98/Me, clear
the [Enable banner] check box on the
[Printer Settings] tab in the printer
properties dialog box.
• Under Windows 2000/XP, clear
the [Enable banner] check box on the
[NetWare Settings] tab in the printer
properties dialog box.
• Under Windows NT 4.0, clear the
[Enable banner] check box on the
[NetWare Settings] tab in the printer
properties dialog box.
Printing after resetting the machine
After resetting the remote printer, the
connection from the print server will
be cut off for about 30-40 seconds be-
fore re-connecting. Depending on the
NetWare specification, print jobs may
be accepted, but they will not be
printed during this interval.
When using the machine as a remote
printer, wait about two minutes after
resetting before attempting to print.
When Using IPP with
SmartNetMonitor for Client
When using IPP with SmartNetMoni-
tor for Client, note the following:
• The network printer can only re-
ceive one print job from SmartNet-
Monitor for Client at a time. While
the network printer is printing, an-
other user cannot access it until the
job is finished. In this case, Smart-
NetMonitor for Client tries to ac-
cess the network printer until the
retry interval expires.
• If SmartNetMonitor for Client can-
not access the network printer and
times out, it will stop sending the
print job. In this case, you should
cancel the paused status from the
print queue window. SmartNet-
Monitor for Client will resume ac-
cess to the network printer. You
can delete the print job from the
print queue window, but canceling
a print job printed by the network
printer might cause the next job
sent from another user to be incor-
rectly printed.
• If a print job sent from SmartNet-
Monitor for Client is interrupted
and the network printer cancels
the job because something went
wrong, send the print job again.
• Print jobs sent from another com-
puter do not appear in the print
queue window, regardless of pro-
tocol.
• If various users send print jobs us-
ing SmartNetMonitor for Client to
network printers, the printing or-
der might not be the same as that
in which the jobs were sent.
• An IP address cannot be used for
the IPP port name because the IP
address is used for the SmartNet-
Monitor for Client port name.
To Next Page
Loading...
