UNIX Configuration
4
1
Using the Installation Shell Script
The installation shell script helps the setup process. The installation shell script
automates some of the tasks in configuring /etc/hosts, /etc/printcap; creating
the spool directory for BSD UNIX; and running the “lpadmin” command for
System V UNIX.
Preparation
The installation shell script can be used on the following workstations (it can-
not be used with other types of workstations):
• SunOS 4.x.x, 5.x
• Solaris 2.x, 7, 8
• HP-UX 8.x, 9.x, 10.x, 11.x
• Redhat Linux 5.2, 6.x, 7.0, 7.1, 7.2
• UnixWare 7.1.1
• OpenServer 5.06
Depending on security settings made at installtion, the “rsh”/“rcp”/“telnet”
commands may not be usable with Red Hat 7.1 or later versions. Change the
security level to allows use of “rsh”/“rcp”/“telnet”. For more information
about how to change the setting, see the operating instructions for Red Hat.
When you use NIS (Network Information Service) or DNS, you should con-
figure the server before running the installation shell script.
For more information about the configuration utility of your operating sys-
tem, see the manual that comes with that utility.
To Next Page
Loading...
