UNIX Configuration
30
1
Staple
Specify the staple position.
Limitation
❒ Before executing the “staple” command, make sure the number of collated
sets and the output tray is specified.
❒ When using this option, the optional finisher unit is required.
❒ When printing with this option, be sure to specify the optional finisher using
“finisherproof” or “finishershift” as the value, for example “outbin=finisher-
proof”. For more information about the optional finisher unit, see p.25 “Out-
put Tray”.
Note
❒ Available staple positions vary depending on the type of output tray you have
installed. For more information about stapling, see
Printer Reference 2
(PDF file)
on the CD-ROM labeled “Operating Instructions for Printer / Scanner”.
staple=value of staple position
The following sample shows how to print with the staple on the upper left using
finisher shift tray (host name: “nphost”; file name: “file1”):
• rsh
% rsh nphost print staple=lefttop,outbin=finishershift <
file1
• rcp
% rcp file1 nphost:staple=lefttop,outbin=finishershift
• ftp
ftp> put file1 staple=lefttop,outbin=finishershift
Position Value
Off off
Upper left lefttop
Upper right righttop
Upper left slant lefttopslantport lefttopslantland
Upper left vertical lefttopvertport lefttopvertland
Left 2 left2port left2land
Right 2 right2port right2land
Upper right vertical righttopvertport righttopvertland
Upper right slant righttopslantport righttopslantland
Upper right horizontal righttopphorizport righttophorizland
Upper 2 top2port top2land
Upper left horizontal lefttophorizport lefttophorizland
To Next Page
Loading...
