Remarks
134
6
Maintaining Your Machine
If the exposure glass, exposure glass
cover, or ADF belt is dirty, copy clari-
ty may be reduced. Clean these parts
if they are dirty.
❖
❖❖
❖ Cleaning the machine
Wipe the machine with a soft,
damp cloth, and then wipe it with
a dry cloth to remove the water.
Important
❒ Do not use chemical cleaners or or-
ganic solvents, such as thinner or
benzene. If such substances get in-
side the machine or melt plastic
parts, a failure might occur.
❒ Do not clean parts other than those
explicitly specified in this manual.
Other parts should only be cleaned
by your service representative.
Cleaning the Exposure Glass
Clean 1 and 2.
Cleaning the Exposure Glass
Cover
Cleaning the Auto Document
Feeder
Clean 1 and 2.
GDSH050J
ZGJS826E
GDSH130J
RussianC3_AEgsg-F_FM.book Page 134 Monday, June 16, 2003 6:35 PM
To Next Page
Loading...
