Using Key Operator Settings
165
9
❒ You can select to receive only from
programmed senders or receive
only from senders other than those
programed in “User Parameters”.
See p.158 “User Parameters”
(switch 08, bit 2).
❒ If you select “OFF” for Authorized
RX in “Initial Set Up”, the settings
will be the same as the Reception
Mode settings. See p.144 “Recep-
tion Settings”.
❒ You can change Special Senders in
the same way as you program
them.
Forwarding
Use this function to print received
messages, and then transfer them to
those receivers programmed before-
hand.
It is also possible to forward faxes
sent only by senders programmed as
Special Senders.
Note
❒ To use this function, program your
Special Senders, and then select
“ON” for “Forwarding” in “Recep-
tion Settings”. See p.144 “Recep-
tion Settings”.
❒ If you specify “ON” in “Forward-
ing” and select [Same as basic set-
tings], the fax message will be
forwarded to the other ends pro-
grammed in “Specify End Receiv-
er”. See p.155 “Forwarding”.
❒ If you do not program any Special
Senders, the machine transfers all
incoming documents to the other
end specified in “Specify End Re-
ceiver”.
❒ You can specify e-mail address as
receiver.
Reception File Print Quantity
Use this function to print the speci-
fied number of copies of documents
received from programmed senders
(Special Senders). If you do not pro-
gram any Special Senders, the ma-
chine prints the specified number of
copies for all received documents.
Limitation
❒ You cannot use multi-copy print-
ing with Polling Reception, Free
Polling, Confidential Reception, or
Memory Lock.
Note
❒ You can specify up to 10 copies.
Print 2 Sided
The optional duplex unit is required.
Use this function to print on both
sides of paper.
Limitation
❒ If you select the bypass tray for
“Paper Tray”, duplex printing is
disabled.
Memory Lock
Use this function to store incoming
documents from programed senders
(Special Senders) in memory without
printing them. People without the
Memory Lock ID cannot print the
documents, and therefore this func-
tion is useful for receiving confiden-
tial documents. If you do not
program any senders, the machine re-
ceives fax message from all senders
using Memory Lock reception.
Reference
p.184 “Programming a Memory
Lock ID”
RussianC3Fax-combine-AE_F_FM.book Page 165 Monday, July 14, 2003 2:36 PM
To Next Page
Loading...
