Printing Options
99
5
Page Separation and Length
Reduction
When the size of a received message
is longer than the paper loaded in the
machine, each page of the message
can be split and printed on several
sheets, or reduced and printed on a
single sheet. For example, this func-
tion splits the message if the message
length is 20 mm (0.79") or longer than
the paper used. The message is re-
duced if it is less than 20 mm (0.79").
When a message is split, an asterix (*)
is inserted at the split position and
about 10 mm (0.39") of the split area is
duplicated on the top of the second
sheet.
Note
❒ Your service representative can
customize this function with the
following settings:
• Reduction
• Print split mark
• Overprinting
• Overprinting length
• Guideline for split
❒ You can adjust the overprinting
and reduction lengths within the
following ranges:
• Overprinting length: 4 mm
(0.16"), 10 mm (0.39"), 15 mm
(0.59")
• Guideline for split: 5-155 mm (5
mm steps)/0.2"-6.1" (0.2" steps)
Reverse Order Printing
Normally, received pages are printed
and stacked on the tray in the order
they are received. If you turn this
function on, the machine will start
printing the message from the last
page received.
Note
❒ You can turn this function on or off
using Reception Settings. See p.144
“Reception Settings”.
❒ When this function is on, the first
page will be printed last.
❒ This function uses Memory Recep-
tion.
RussianC3Fax-combine-AE_F_FM.book Page 99 Monday, July 14, 2003 2:36 PM
To Next Page
Loading...
