Using the Installation Shell Script
13
1
HP-UX
❖
❖❖
❖ Adding the IP address and host name to the /etc/hosts file
The following line is added to the /etc/hosts file. The IP address and printer
host name previously entered in the installation script will be used:
192.168.15.16 np # Network Printer
•“192.168.15.16” is the IP address, “np” is the host name, the comment
comes after the #.
Note
❒ The /etc/hosts file contains a list of IP addresses and names of all hosts
communicating on the network. Each entry is delimited with a space or a
tab, and each line is separated with a return.
❒ If you do not use NIS or DNS, you must enter the IP address and host name
of each workstation using the network printer in the /etc/hosts file.
❖
❖❖
❖ Registering the printer
The installation shell script registers the printer as a remote printer using the
procedure below:
A
Stop the scheduler.
/usr/lib/lpshut
B
Register the printer.
/usr/lib/lpadmin -Pnp -v/dev/null -mrmodel
-ormnphost -orpoption -ob3
•“np” is the printer name, “nphost” is the host name.
For more information about “option”, see p.19 “Specifying the Device
Option”.
“lp” will be assigned if the option is not used.
C
Set the printer so the print job is put in the print queue.
/usr/lib/accept np
D
Set the printer to perform the print job.
/usr/lib/enable np
E
Restart the scheduler.
/usr/lib/lpsched
To Next Page
Loading...
