Other Transmission Features
76
4
Programming the Stamp Sender
Name
A Press [Change] for Stamp Send-
er Name.
B Press the name of the user to be
stamped, and then press [
OK
].
Note
❒ The set user name is dis-
played when the user code
has been stored. See General
Settings Guide.
❒ You can switch titles by
pressing the title keys.
❒
To stamp a non-programmed
user name, press
[Non-pro-
grammed Name]
, and then en-
ter the user name.
❒ If you do not want to stamp
the sender's stamp, press [
*Do
not Stamp
].
Programming the Reduced
Image Transmission
A Press [ON] for Reduced Image
TX.
Note
❒ Press [OFF] if you do not
want to do a reduced trans-
mission.
Programming the Auto Reduce
A Press [ON] for Auto Reduce.
Note
❒ Press [OFF] if you do not
want to use the Auto Reduce
function.
Programming the Default ID
Transmission
A Press [ON] for Default ID TX.
Note
❒ Press [
OFF
] if you do not
want to use ID transmission.
E
EE
E
Press [
OK
] twice.
F
FF
F
Specify the destination, and then
press the {
{{
{Start}
}}
} key.
RussianC3Fax-combine-AE_F_FM.book Page 76 Monday, July 14, 2003 2:36 PM
To Next Page
Loading...
