Ricoh Aficio 2022 - Page 783

Initial Scanner Setup
17
2
❖
❖❖
❖ Change Initial Mode
If you use the settings which are
displayed when modes are
cleared, reset, or immediately after
the operation switch is turned on
as the initial mode, select [Stand-
ard].
Select [Program No.10] when you
use the settings stored in Program
No.10 as the initial mode.
Selecting a custom size
When selecting [Custom size] as the
scan size, follow the procedure be-
low.
A
AA
A
Press [Custom size] on the Scan
Size Setting screen.
B
BB
B
Enter the original size with the
number keys.
Select and enter values for [X1] and
[Y1], and then press the {
{{
{#}
}}
} key.
C
CC
C
Enter the scan starting point in re-
lation to the standard scan start-
ing point.
Select and enter values for [X2] and
[Y2], and then press the {
{{
{#}
}}
} key.
D
DD
D
Enter the scan size (area) with the
number keys.
Select and enter values for [X3] and
[Y3], and then press the {
{{
{#}
}}
} key.
Depending on how the original is
positioned, the scan area will be as
follows:
shows the face of the original.
shows the back of the original.
shows the feeding direction.
X3 X2
X1
Y2
Y1
Y3
When placed on the exposure glass
X3X2
X1
Y2
Y1
Y3
X3X2
X1
Y2
Y1
Y3
When placed in the ADF
ZHSY055E
X1
X3X2
X1
Y2
Y1
Y3
Y2
Y3
X3 X2
X1
Y1
Y1
Y2
Y3
X3 X2
Original orientation
Original orientation