Ricoh Aficio 2022 - Page 925

User Tools Menu (System Settings)
37
3
Note
❒ Default: Auto-Obtain (DHCP)
❒ If you use the interface for Eth-
ernet and IEEE 1394 (IP over
1394) at the same time, settings
must be made carefully. See
p.109 “Using DHCP”
❒ When you use the IEEE 1394 in-
terface on a network, you can-
not use the Ethernet interface in
the same domain. To use both
interfaces in the same domain,
set different values for the [Sub-
net Mask].
❒ The physical address (MAC ad-
dress) also appears.
❖
❖❖
❖ IP over 1394
When you use the IP over 1394
function of the IEEE 1394 interface
to connect the machine to the net-
work, or you print from computer
with the IP over 1394 driver, you
must specify [Active]for [IP over
1394].
• Active
• Inactive
Note
❒ Default: Active
❖
❖❖
❖ WINS Configuration
You can specify the WINS server
settings.
• ON
If [ON] is selected, specify the
[WINS Server] IP address as
“xxx.xxx.xxx.xxx” (“xxx” indi-
cates a number).
If DHCP is in use, specify the
[Scope ID].
• WINS Server:000.000.000.000
• Scope ID
• OFF
Limitation
❒ Enter [Scope ID] using up to 31
alphanumeric characters.
Note
❒ Default: OFF
❖
❖❖
❖ SCSI print (SBP-2)
When you print using the SCSI
print client function supported by
Windows 2000 or Windows XP,
you must set SCSI print.
• Active
• Inactive
Note
❒ Default: Active
❖
❖❖
❖ Bidirectional SCSI print
Specifies the printer's response
mode etc. for status requests when
using the IEEE 1394 interface.
• ON
• OFF
Note
❒ Default: ON
❒ If this is set to [OFF], bidirection-
al communication will not
work.
❖
❖❖
❖ Host Name
Specify the host name.
❖
❖❖
❖ Domain Name
Specify the domain name.