Ricoh Aficio 2022 - Page 938

Windows Configuration
50
4
Configuring a Windows NT
Computer
Follow the procedure below to con-
figure a Windows NT computer to
use NetBEUI.
A
AA
A
Open [Control Panel], and then
double-click the Network icon.
Make sure [NetBEUI Protocol] is
listed in the [Network protocols] box
on the [Protocols] tab.
Note
❒ If NetBEUI is not installed, click
[Add] on the [Protocols] tab to in-
stall it. For more information
about installing NetBEUI, see
Windows NT Help.
B
BB
B
Change the Lana Number. Click
the [Services] tab, click [NetBIOS In-
terface] in the [Network services]
box, and then click [Properties].
C
CC
C
Click the Lana Number corre-
sponding to the Nbf protocol in
the [Network Route] column, and
then click [Edit].
D
DD
D
Enter “0” as the Lana Number.
Note
❒ If the other protocol's Lana
Number is “ 0 ” , you must
change the Lana Number to a
number other than “0”.
E
EE
E
Click [OK].
F
FF
F
Click [Close] to close the [Network]
dialog box.
The confirmation message about
restarting appears.
G
GG
G
Click [Yes].
Note
❒ After you change the Lana
Number, you must restart the
computer.