Ricoh Aficio 2022 - Page 953

Printing with NetWare
65
5
H
HH
H
Click the [NetWare] tab, and then
make the following settings:
A In the [Logon Mode] area, click
[File Server Mode] or [NDS Mode].
Note
❒ If [File Server Mode] is select-
ed, a connecting destination
will be chosen based on the
string entered in step C.
❒ If [NDS Mode] is selected, a
connecting destination will
be chosen based on the string
entered in step D.
B In the [Print Server Name(P):] box,
enter the print server name.
Limitation
❒ Enter up to 47 alphanumeric
characters.
C In the [File Server Name(F):] box,
enter the name of the file serv-
er in which the print server is
to be created.
By clicking [Browse(B)…], you
can select a file server among
those listed in the [Browse(B)…]
dialog box.
Limitation
❒ Enter up to 47 alphanumeric
characters.
D In the [NDS Tree(T):] box, enter
the NDS tree name in which to
make the file server.
By clicking [Browse(D)…], you
can select the NDS tree name
and NDS context name from
their lists.
Limitation
❒ Enter up to 32 alphanumeric
characters("-" and "_" can be
used).
E In the [NDS Context(C):] box, en-
ter the context of the print serv-
er.
Limitation
❒ Enter up to 127 alphanumer-
ic characters.
Note
❒ As context, object names are
entered in lower object order
and divided by a period. For
example, if you want to cre-
ate a print server into NET
under d, enter "d".
F In the [Print Server Operation
Mode] area, click [As Print Serv-
er(S)].
G Click [OK] to close the [NIB
Setup Tool - Network board
list] dialog box.
I
II
I
Quit SmartNetMonitor for Ad-
min.
After this step, operate the ma-
chine by following the procedure
from step
I
on p.68 “NetWare 4.x,
5/5.1, 6”. However, steps
N
-C and
N
-D are not required.