Ricoh J001 - Page 206

SM 8-6 J001/J003
8.1.4 PAPER MISFEED: GUIDE PLATE
SERVICE CENTER CALL RESPONSE PROBABLE CAUSE OPERATOR ACTION
SERVICE TECHNICIAN (ST) and/or
NATIONAL RECLAMATION CENTER
(NRC) ACTION
A transport jam occurred during duplex printing.
When the paper was fed to the duplex unit during
duplex printing, the paper stopped and the bottom
edge did not pass the trailing edge sensor.
Ask the operator to try the following procedures to
remove and prevent paper transport jams during
duplex printing. Also, check inside the duplex unit
or printer for paper. If you find paper inside the
duplex unit or printer, remove it, and then press
the [Paper Feed] key.
1. The paper was pulled in from the output tray
during reversing.
2. Damage.
1. Remove the sheets stacked on the output tray.
2. Repair (ST) or replace (NRC).
(1) Check inside the printer and duplex unit for 2
or more sheets of paper. If the printer is
double-feeding, remove the papers stacked on
the output tray. As a general rule (for all
environments) do not allow more than 100
sheets to stack on the output tray. Allowing
between 100 and 150 sheets to stack on the
output tray (70 g/m
2
with 5% coverage) can
cause poor print quality. To ensure best
quality, do not allow more than 50 sheets to
stack on the output tray.
The paper was pulled in from the output tray during
reversing.
Remove the sheets stacked on the output tray. As
a general rule (for all environments) do not allow
more than 100 sheets to stack on the output tray.
Allowing between 100 and 150 sheets to stack on
the output tray (70 g/m
2
with 5% coverage) can
cause poor print quality. To ensure best quality,
do not allow more than 50 sheets to stack on the
output tray.
(2) ST Descriptions
2-1 Operation impaired by other causes. 1. Sensor damage (trailing edge sensor).
2. Anti-static brush at the output slot is out of
position.
3. Harness disconnected, damaged.
4. Control board malfunction.
5. DC relay board abnormal.
1. Replace trailing edge sensor (ST).
2. Replace the anti-static brushes (ST).
3. Check harness, replace (NRC).
4. Replace control board (NRC).
5. Replace DC relay board (NRC).
CÓPIA NÃO CONTROLADA
CÓPIA NÃO CONTROLADA