Printer Display Summary
SM 4-5 J007/J010/J011
J007/010/
J011
Message Type What It Means
Close Duplex Unit
Cover
Error The duplex unit cover is open. Close it.
Close Top Cover or
reset Duplex Unit
Correctly
Error The top cover is open, or the duplex unit is not installed
and locked in place. Close the top cover, or set the
duplex unit correctly.
Dry Waiting… Status Ink on a printed OHP transparency is drying. Please
wait.
Energy Saver Status The printer is in the energy save mode. It will awaken
from this mode after a key is pushed on the operation
panel when the printer receives a print job.
Guide Board is open
Close the Guide
Board
Error Close the guide board.
Hardware Problem
Ethernet
Error An error has occurred in the network interface board.
Ink Collector Full
Replace Ink Collector
Unit
Error The ink collection unit is full. Replace the ink collection
unit on the back of the printer.
Ink Collector Unit
Almost Full
Error The ink collection unit is almost full. Make sure that an
replacement is available.
Ink Depleted Error Ink has run out in an ink cartridge. Change the
indicated ink cartridge immediately. The printer cannot
be used until the cartridge has been replaced.
Load Paper: Tray #
or Form Feed
Error The tray has run out of paper. Reload the tray. Or you
can push [Form Feed], select the other tray, and push
[#Enter].
Loading Ink… Status The ink tanks inside the print head are filling with ink
from the ink cartridges. Wait for the operation to finish.
Low ink. Error One or more of the ink cartridges is running low.
Determine which cartridge is low and obtain a
replacement. The printer can be used for a short time,
but the cartridge should be replaced as soon as
possible.
Maintenance in
progress…
Status The printer is busy cleaning or flushing the print head.
Please wait.
Offline Status Printer is offline. Push [Online] to set the printer for
printing.
Power Off/On
Call Service if error
reoccurs
Error An error has occurred inside the printer.
To Next Page
Loading...
