SP Tables
SM 5-15 J007/J010/J011
J007/J010
J011
1225 CHG:PITCH:D2
Mj4: 10% → 25% Lookup Table
1226 CHG:PITCH:D3
Mj4: 25% → 35% Lookup Table
1227 CHG:PITCH:D4
Mj4: 35% → 45% Lookup Table
1228 CHG:PITCH:D5
Mj4: 45% → 55% Lookup Table
1229 CHG:PITCH:D6
Mj4: 55% → 65% Lookup Table
1230 CHG:PITCH:D7
Mj4: 65% → 75% Lookup Table
1231 CHG:PITCH:D8 Mj4: More than 75% Lookup Table
Use this SP to configure the charge ID table for printing on glossy paper in
Quality mode. Do this SP when mist build-up on glossy paper in use is clogging
the print head nozzles. This setting is linked to the charge pitch settings (SP1124
to 1131, SP1156 to 1163).
[0 to 0xffff ffff/0/1/---]
Set Charge Area 1
1232 CHG:AREA1:OHP Set Charge of Area 1 for LE/TE: OHP
Use this SP to set the size of the leading and trailing edges of transparencies
(OHP). Do this setting when you want to adjust pitch amount of the charge
applied to the leading and trailing edge of transparencies for printing. The areas
of the leading and trailing edges is shown below.
[5 to 255/0/1/mm]
1233 CHG:AREA1:F
Set Charge of Area 1 for LE/TE: Simplex: Any Other Than
OHP
Use this SP to set the size of the leading and trailing edges for the 1st side of
any paper except transparencies (OHP). Do this setting when you want to adjust
pitch amount of the charge applied to the leading and trailing edges on the 1st
side any paper except transparencies. The areas of the leading and trailing
edges is shown below.
[5 to 255/0/1/mm]
1234 CHG:AREA1:B
Set Charge of Area 1 for LE/TE: Duplex: Any Other Than
OHP
Use this SP to set the size of the leading and trailing edges for the 2nd side
(duplex printing) of any paper except transparencies (OHP). Do this setting when
you want to adjust pitch amount of the charge applied to the leading and trailing
edges on the 2nd side any paper except transparencies for duplex printing. The
areas of the leading and trailing edges are shown below.
[5 to 255/0/1/mm]
Set Charge Area 2
1235 CHG:AREA2:B Set Charge of Area 2 for MID: OHP
Use this SP to set the size of the MID area of transparencies (OHP).
Do this setting when you want to adjust pitch amount of the charge applied to the
To Next Page
Loading...
