Ricoh J001 - Page 84

MAINTENANCE UNIT
J001/J003 3-12 SM
7. Slowly pull the ink supply unit [A] to
the left.
Important! Do not pull the ink supply
unit completely out of the machine. Do
not let the ink supply tubes to
disconnect. The tubes should remain
connected at all times.
8. Disconnect the maintenance [A]
unit
( x 2,  x 2).
NOTE: Disconnect the
maintenance motor connector [B]
from the PCB on the back of the
printer.
9. Slowly remove the maintenance
unit from the printer.
Important! A small hose protrudes
from the bottom of the
maintenance unit. Do not hit this
hose at the time you remove the
maintenance unit from the printer.
This stops ink spillage.
G707R915.BMP
G707R916.BMP
[A]
[A]
[B]
CÓPIA NÃO CONTROLADA
CÓPIA NÃO CONTROLADA