SP Tables
SM Appendix 3-49 M047
Appendix: SP
Mode Tables
5828 066 Job Spooling Clear
This SP determines whether the job interrupted at
power off is resumed at the next power on. This SP
operates only when SP5828 065 is set to 1.
1: OFF (Resumes printing spooled jog.)
0: ON (Clears spooled job.)
5828 069 JobSpooling Protocl
This SP determines whether job spooling is enabled or disabled for each
protocol. This is a 8-bit setting.
0: LPR/ 1: FTP (Not Used)/ 2: IPP/ 3: SMB/ 4: BMLinks (Japan Only)/
5: DIPRINT/ 6: Reserved (Not Used)/ 7: Reserved (Not Used)
5828 090 TELNET
Disables or enables Telnet operation. If this SP is
disabled, the Telnet port is closed.
[0to1 / 1 /-]
0: OFF
1: ON
5828 091 Web
Disables or enables the Web operation.
[0to1 / 1 /-]
0: OFF
1: ON
5828 145
Active IPv6 Link
Local
This is the IPv6 local address referenced on the
Ethernet or wireless LAN (802.11) in the format:
"Link-Local address" + "Prefix Length"
The IPv6 address consists of a total 128 bits
configured in 8 blocks of 16 bits each. These
notations can be abbreviated. See "Note: IPV6
Addresses " below this table.
To Next Page
