Telephone key
Description of function
There are 9 bit flags based on the 1--9 key of the telephone. After you enter into the telephone control mode,
and enter # 0, the P0 block would give off one trigger. If you enter # 8, the P8 would give one trigger
Operation Instructions of the Voice function for x-Messenger
1.The first five sections (section 0, section 1, section 2, section 3, section 4) are for
the voice system. Users cannot record the five sections randomly.
2.Section 5 to section 99 of the voice module are the voice sections for users
programming and can be used randomly. However, users must start recording from
section 0 while the functions of section 0 to section 4 are fixed by the system.
Functions from section 0 to section 4 are as follows:
Section 0: When dialing out through the “sms message input/output” block, it will broadcast this section
“Please enter No. 0 key and receive the information”. (When recording, users must record this voice
contents “Please enter No. 0 key and receive the information”)
Section 1: the voice prompt for confirming the user status. It will be broadcasted
when x-Messenger system number has been dialed or x-Messenger dialed out to configured user. Normal
broadcasting can be carried out with this section.
Section 2: the voice prompt for the correct password. It will be broadcasted when the
correct password is used. Normal broadcasting can be carried out with this section.
To Next Page
Loading...
