106 Rockwell Automation Publication 2713P-UM001G-EN-P - May 2022
Chapter 7
Resistance to Chemicals
The outer surfaces of the terminal including the bezel, touch screen overlay, and
panel gasket are tested for chemical resistance. Some of the chemicals can cause
discoloration, but they do not interfere with the operation of the terminal.
Clean the Display
To clean the display, follow these steps.
1. Disconnect power from the terminal at the power source.
2. To clean the display and help prevent scratches, use a clean sponge or soft
cloth with mild soap or detergent.
3. Dry the display with a chamois or moist cellulose sponge to avoid water
spots.
Remove Paint and Grease
To remove paint or grease from the bezel that is properly mounted in a NEMA,
UL Type, or IP rated enclosure, follow these steps.
1. Rub lightly with isopropyl alcohol (70% concentration).
2. To remove residue, use a mild soap or detergent solution.
3. Rinse with clean water.
TIP For more information on chemical resistance of the product, go to
https://rockwellautomation.custhelp.com/
and search the Knowledgebase for
keywords ‘Chemical Resistance PanelView Plus’.
IMPORTANT Do not operate the terminal in direct sunlight. Direct exposure to ultraviolet
light can discolor the touch screen.
ATTENTION: Do not use abrasive cleaners or solvents, they can damage the
display. Do not scrub or use brushes.
Do not apply cleaning solution directly on the terminal screen, the solution can
drip or seep onto the gasket. Apply cleaning solution to a clean sponge or soft
cloth, and gently wipe the screen to remove the dirt and grime.
ATTENTION: Do not clean a display while power is applied. If you clean
a display while power is applied, you can unintentionally activate
screen items.
To Next Page
Loading...
Need help?
General
