30 Rockwell Automation Publication 2713P-UM001G-EN-P - May 2022
Chapter 2
b. Tilt the terminal toward the panel cutout and guide upward into the
cutout. Make sure that the levers stay intact.
c. Pull the top of the terminal toward you to verify that the levers are still
intact and the terminal is stabilized in the panel.
d. Insert the remaining levers in the slots by using the orientations in
Figure 5 on page 28
that are correct for your terminal.
The direction that you rotate the levers varies for each terminal size.
4. Slide and rotate each lever to a notch that is one or two positions greater
than the final lock position. Start with the first lever in the sequence.
For example, if the final lock position is 3, slide the lever to notch 4 or 5.
a. See Table 10 on page 26
to get the final lock position of the levers.
b. See Figure 5 on page 28
to get the locking sequence.
TIP The levers help prevent the terminal from falling out of the panel.
TIP To help position the levers and identify the final slot position, use
the alignment marks or previous marks you made on the bezel.
To Next Page
Loading...
