I–2
Index
F
fan power, 3-5
fan terminations, 3-5
180A–500A, 3-5
650A–1000A, 3-5
97A and 135A, 3-5
fault
auxiliary contact, 9-2
buffer, 9-2
codes, 9-2
definitions
comm fault, 9-5
controller temp, 9-5
excess starts/hour, 9-5
jam detection, 9-4
line fault, 9-3
open gate, 9-5
overload protection, 9-4
overvoltage and undervoltage protection, 9-3
phase reversal, 9-3
power loss, 9-3
stall protection, 9-4
underload, 9-4
voltage unbalance, 9-4
display, 9-1
full voltage start
description of, 1-4
programming parameters, 4-10
fuses, recommended, 2-10
G
grounding provision, 3-6
H
heat dissipation, 2-2
human interface module, 7-1
human interface module (HIM), 2-12
connecting the HIM to the controller, 2-13
control enable, 2-13
series A human interface modules, 2-14
series B human interface modules, 2-15
I
inspection, 2-1
installation, 2-1
interfacing, 8-4
J
jam detection, 9-4
K
keypad description, 1-11, 4-1
L
ladder logic program, 8-9, 8-15
line fault, 1-9, 9-3
logic control data, 8-1
M
metering, 1-10, 6-1
motor data entry, 5-1
motor codes, 5-2
motor overload protection, 2-11
bypass configuration, 2-11
multi-motor protection, 2-11
series A human interface modules, 2-14
series B human interface modules, 2-15
two-speed motor connection, 2-11
mounting, 2-4
dimensions, 2-4, 2-5, 2-6, 2-7, 2-8
MOV fuse replacement, 10-11
O
open gate, 1-9
options, 7-1
overload protection, 1-5
overvoltage protection, 9-3
To Next Page
Loading...
Need help?
General
