Rockwell Automation SMC Dialog Plus

Index
I–3
P
parameter
electrically erasable programmable read-
only memory (EEPROM), 4-6
listing of, 4-4, 8-3, B-1
management of, 4-6
modifying of, 4-8
random access memory (RAM), 4-6
read only memory (ROM), 4-6
using parameter management, 4-7
phase rebalance, 1-5
phase reversal, 1-9, 9-3
power factor correction capacitors, 2-9
power loss, 9-3
power module (and interface board) resistance
check, 10-11, 10-12, 10-13, 10-14
feedback resistance, 10-12, 10-13
gate lead resistance, 10-12, 10-13
preparation, 10-11
shorted SCR test, 10-12, 10-13
thermistor resistance, 10-12, 10-14
precautions, 2-2
preset slow speed option
description of, 1-13
programming parameters for, 7-3
sequence of operation, 7-19
wiring diagrams, 7-14, 7-15, 7-16, 7-17
programming
advanced, 4-12, 4-13
basic, 4-11
example settings, 4-13
password, 4-5
programming menu, 4-1
programming parameters, 7-3
keypad, 1-11
protection and diagnostics, 1-5
excessive starts/hour, 1-10, 9-5
line faults, 1-9, 9-3
open gate, 1-9, 9-5
overload, 1-5
overtemperature, 1-10
stall and jam, 1-8
underload, 1-9, 9-4
protective cover removal, 10-10
protective modules, 2-11
pump control option
description of, 1-13
programming parameters for, 7-3
sequence of operation, 7-12
wiring diagrams, 7-5, 7-6, 7-7, 7-8, 7-9,
7-10
R
receiving the controller, 2-1
renewal parts, C-1
S
scale factor conversion, 8-3
SCANport, 8-1
location, 1-11
search, 4-5
selectable kickstart, 1-3
serial communication, 8-1
Slow Speed with Braking option, description of,
1-15
Slow-speed with Braking option
programming parameters for, 7-4
sequence of operation, 7-25
wiring diagrams, 7-21, 7-22, 7-23, 7-24
SMB Smart Motor Braking option
description of, 1-14
programming parameters for, 7-4
sequence of operation, 7-13
SMB Smart Motor Braking option, wiring
diagrams, 7-5, 7-6, 7-7, 7-8, 7-9, 7-10
SMC status data, 8-3
soft start option
description of, 1-2
programming parameters, 4-9
soft stop option
description, 1-12