Programming
4-5
Password
The SMC Dialog Plus controller allows the user to limit access to the
programming system through password protection. This feature is a
disabled with a factory-set parameter with a default setting of 0. To
modify the password or login after a password is programmed,
complete the procedure below.
①
After you have completed the programming process, re-enter the Password mode to log out. This
will eliminate unauthorized access to the programming system.
Note: If you lose or forget the password, contact your nearest
Allen-Bradley sales office. You can also call 1-800-765-
SMCS (765-7627) for assistance.
Search
The Search mode allows the user to view only those parameters that
have settings other than the factory default values. This mode is
available only when using Bulletin 1201 human interface module.
Description Action Display
——
1. Press any key to go
from the status display
to the Choose Mode
menu.
2. Scroll with the Up/
Down keys until the
Password option
appears.
3. Press the Enter key to
access the Password
menu.
4. Press the Enter key.
5. Press the Up/Down
keys to enter the
desired number. If you
are modifying the
password, make a note
of it as displayed.
6. Press the Enter key
after you have
completed modifying
the password.
①
STOPPED
0.0 AMPS
CHOOSE MODE
DISPLAY
or
CHOOSE MODE
PASSWORD
PASSWORD
|MODIFY
Options:
Login, Modify
Logout
ENTER PASSWORD
_ _ _ _ _
or
ENTER PASSWORD
#####
CHOOSE MODE
PASSWORD
To Next Page
Loading...
Need help?
General
