Rockwell Automation SMC Dialog Plus

Index
A
accessories, D-1
Accu-Stop option, wiring diagrams, 7-14, 7-15,
7-16, 7-17
Accu-Stop, description of, 1-15
Accu-Stop option
programming parameters for, 7-4
sequence of operation, 7-20
B
Bulletin 825 converter module
description, 2-16, 2-17, 2-18
for metering, 1-10
in a bypass configuration, 2-11
part numbers of, D-1
rating of, 5-2
with fanning strip connection, 3-6, D-1
with overload protection, 1-5
with phase rebalance, 1-5
C
calibration, 5-1
procedure, 5-3
clear fault, 9-1
communication, 1-11, 8-1
communication (comm) fault, 9-5
communication modules, 2-16, 8-4
control enable, 8-2
control module removal, 10-6, 10-7, 10-8, 10-9
180-360 amp, 10-7, 10-8
24-135 amp, 10-6
500-1000 amp, 10-9
control module replacement, 10-10
control options, 1-12, 1-13, 1-14, 1-15
control power, 3-4
control voltage, 3-4
control wiring, 3-4
control terminals, 3-6
controller overview, 1-1
controller setup, 4-11
advanced setup, 4-12
controller temperature (temp), 9-5
current limit start
description of, 1-3
programming parameters, 4-9
D
datalinks, 8-4
diagnostics, 1-5, 1-7, 9-1
dimension drawings
180A–360A controllers, 2-6
24A, 35A, and 54A controllers, 2-4
500A controllers, 2-7
650A–1000A controllers, 2-8
97A and 135A controllers, 2-5
dual ramp start
description of, 1-4
programming parameters for, 4-10
wiring diagram of, 3-9
E
EMC, 2-18, 2-19
enclosures, 2-2, 2-3
energy saver, 1-5
ESD, effects of, 2-2
excess starts per hour, 1-10