Effectivity: 914 Series
Edition 2 / Rev. 0
d04283
page 135
July 01/2008
BRP-Rotax
INSTALLATION MANUAL
23.3) Oil pressure sensor
See Fig. 93/94.
- location: oil pump housing
- position of connection on oil pressure pick-up (1):
200
(
Ω)
(bar)
150
100
50
0
108642
Fig. 94
Fig. 93
04903
00229
- connection of
pick-up wiring: single pole screw connection for ring terminal 3 to DIN 46225
(tightening torque, max. 1Nm (8,848 in lb)
- grounding:via engine block
- graph of resistance over pressure
■ CAUTION: The graph resistance over pressure has been determined, and is
effective at the following conditions only.
ambient temperature: 20 °C (68 °F)
voltage: 12 V
tolerance: ± 5%
BRP-Rotax offers a non-certified pressure gauge. Refer to Illustrated Parts Catalog,
latest issue.
▲ WARNING: Certification to the latest requirements such as FAR of EASA has to be
conducted by the aircraft manufacturer.
04870
Axes
x axis
mm
y axis
mm
z axis
mm
ca. -100 75 ca. -150
point of
connectio
1
To Next Page
Loading...
