4.4 Setting the date and time
When you start up the device for the first time, you first need to set date and
time.
1. Ensure that the measuring mat is correctly suspended in the storage
compartment of the monitor ➔ Suspending measuring mat in storage
compartment.
2. Connect the device to the power supply.
3. Press the ON/OFF button of the monitor.
The LED of the button is white.
The initial start screen appears.
4. Enter the current date:
a) Press input field
b) Enter the current date using the keypad
c) Confirm your entry by pressing the button
5. Enter the current time:
a) Press input field
b) Enter the current time using the keypad
c) Confirm your entry by pressing the button
6. Press the button.
7. Continue operating the device - you have the following options:
► leave device switched on, charge rechargeable battery (recommended):
➔ Charging rechargeable batteries
► perform bioimpedance measurement using the power supply:
➔ Operation
► configure device using the power supply: ➔ For administrators: configur-
ing seca 525
To Next Page
Loading...
