28 •
Logging out/switching user ► Press the Logout button.
You will be logged out.
The login window is displayed.
Another user can log in ➔ Logging in.
Automatic standby The device automatically switches to standby if there are no entries on the
device for 5 minutes. This has the following effects:
• the LED of the ON/OFF button is green.
• the touchscreen display goes out.
• all entries are retained.
• the measuring mat remains switched on.
• after you switch back on, you have to log in again.
• operation can be continued.
If no entries are made for 10 minutes, the device switches off:
• the LED of the ON/OFF button goes out.
• data which have not been saved are lost.
• the measuring mat switches off.
• after you switch back on, you have to log in again.
• entries have to be made again.
Switching the monitor to standby
► Briefly press the ON/OFF button of the monitor.
the LED of the ON/OFF button is green. The touchscreen display goes
out.
The monitor is on standby.
Switching off WARNING!
Electric shock
The monitor cannot be de-energized by pressing the ON/OFF button.
► Always remove the power supply connector and remove the re-
chargeable battery (if present and intended for technical purposes)
if the device needs to be de-energized, e.g. for the hygiene treat-
ment.
1. Ensure that the measuring mat is correctly suspended in the storage
compartment of the monitor ➔ Suspending measuring mat in storage
compartment.
2. Keep the ON/OFF button of the monitor pressed until the touchscreen
display and the LED of the ON/OFF button go out.
The device is switched off.
The measuring mat switches off automatically.
Logout
To Next Page
Loading...
