7. Continue the measurement as outlined below.
► The device asks you to use the control panel on the measuring mat:
continue at Step 7. in the section entitled ➔ Performing offline mea-
surement (WiFi not available)
► If there is no request to use the control panel on the measuring mat:
continue at Step 8. in this section
8. Connect the measuring mat ➔ Connecting the measuring mat.
9. Correct the patient position displayed if necessary, using the buttons
of the measuring mat.
The LED of the patient position entered is green.
10. Press the button on the monitor.
The measuring process starts:
11. Remove the electrode cables from the electrodes.
12. Suspend the measuring mat in the storage compartment of the monitor.
The measuring process is complete.
You can now continue as outlined below.
► Press the evaluation tab ➔ Evaluating the measurement.
► Press the button: add a comment.
Monitor
Process step
Electrode
symbol
Progress
symbol
1. Electrodes being tested
2.
Measurement in progress
seca patient file being updated
on the measuring mat
3.
Updated seca patient file being
transmitted to the monitor
4. Measuring process complete Off
To Next Page
Loading...
