| 4 - Instruction manual
Connecting to the network (power supply and configuration)
The PoE/Ctrl RJ-45 socket (Dante I) is used to both power the receiver via Power over
Ethernet and configure it using the Sennheiser Control Cockpit software (see Controlling
and monitoring the receiver via the network).
• In your network you can either use a switch that provides PoE or a PoE injector.
Outputting digital audio signals
The Dante® interface with two RJ-45 sockets, Dante I and Dante II, is used for outputting
digital audio signals. The interface supports redundant output and daisy-chaining (see above
for details).
105
To Next Page
Loading...
