| 4 - Instruction manual
Putting the receiver into operation
Observe the following information during startup.
Connecting/disconnecting the receiver to/from the power supply system
The receiver is powered using Power over Ethernet. As soon as the power supply is
established, the receiver switches on automatically. There is no separate on/off switch.
• See Connecting to the network (power supply and configuration)
When the receiver starts, all four LEDs light up green for about 20 seconds. Then the LEDs
change to displaying the status of the respective channel.
• See Meaning of the status LEDs
Operating and configuring the receiver
The receiver is operated and configured using the Sennheiser Control Cockpit control
software. You cannot operate the receiver on the device itself.
• See Controlling and monitoring the receiver via the network
115
To Next Page
Loading...
