| 4 - Instruction manual
Setting up the receiver
This sections describes how to set up the receiver.
You can also install the receiver in a fixed location, e.g. in a 19" rack. You can find more
information about installing the receiver in a fixed location under: Installing receivers in a
rack.
Affixing the device feet
Only affix the device feet if you are setting the receiver up in the stand-alone
position instead of installing it in a 19" rack. The device feet will get in the way
if the receiver is installed in a rack.
NOTICE
Risk of staining furniture surfaces
The device feet may cause marks if they come into contact with furniture
surfaces.
▷ Do not place the device on sensitive surfaces.
▷ Clean the recesses for the device feet at the base of the receiver.
▷ Affix the device feet to the recesses of the receiver.
▷ Place the receiver on a flat, horizontal surface.
➥ The device feet will adhere reliably to the receiver only after some time. Avoid
moving the receiver during this time.
84
To Next Page
Loading...
