| 4 - Instruction manual
Installing antenna splitters in a rack
This chapter describes how to install a single antenna splitter or two antenna splitters side
by side in a rack.
To install the antenna splitter in a rack, you need the GA 4 mounting kit, see GA 4 mounting
kit.
To fasten the mounting angles (to install an antenna splitter):
▷ Remove the two recessed head screws on each side of the antenna splitter.
▷ Fasten the mounting angles to the sides of the antenna splitter by tightening the
previously removed recessed head screws.
➥ Make sure that the angled ends of the mounting angles point forward.
256
To Next Page
Loading...
