| 3 - System planning
Single-room setup with SL Rack Receiver DW only
▷ Install all receivers in one rack (see Installing receivers in a rack).
▷ Connect all cables for the receivers (see Connecting the receiver).
▷ MMount all antennas as recommended and feasible (see Recommendations on
antenna mounting).
▷ Ensure that all receivers are switched off.
▷ Switch on the first receiver. This receiver will become the Master.
▷ If necessary, pair a transmitter. Only if necessary, as the sets are delivered already
paired.
▷ Wait until both the LED of the receiver and the LED of the transmitter light up green.
▷ Perform a walk test to ensure the best reception coverage (see Performing a walk test
(reception quality)).
▷ Switch on all other receivers. They will synchronize with the Master. Make sure to
leave the Master receiver switched on during this step.
Related information
Single-room setup with SL Multi-Channel Receiver DW only
Single-room setup with both SL Rack Receiver DW and SL Multi-Channel Receiver DW
Multi-Room Mode setup with SL Rack Receiver DW only
Multi-Room Mode setup with SL Multi-Channel Receiver DW only
Multi-Room Mode setup with both SL Rack Receiver DW and SL Multi-Channel
Receiver DW
62
To Next Page
Loading...
