| 4 - Instruction manual
Controlling and monitoring the charger over the network
You can connect the CHG 2N charger to a network using a router or switch, which allows you
to monitor and control the accupack’s charge level using the Sennheiser Control Cockpit
software and to modify the CHG 2N charger’s network configuration.
For more information on controlling a system in the network using the Sennheiser Control
Cockpit software, refer to the instruction manual of the software.
Please note that the host PC on which the Sennheiser Control Cockpit Service is installed
must be in the same network as the devices that are to be monitored and controlled.
Related information
Connecting the charger to the network
Integrating the charger into a network with DHCP
Integrating the charger into a network without DHCP using Auto IP
Integrating the charger into a network without DHCP using Fixed IP
Connecting a pre-configured charger to the Sennheiser Control Cockpit
Resetting the charger’s network settings
219
To Next Page
Loading...
