| 4 - Instruction manual
▷ Long-press the PAIR button of the corresponding transmitter until its status LED
flashes alternately green and red.
➥ The Press pair on receiver message appears on the display panel of the
transmitter (SL Handheld DW and SL Bodypack DW only).
Once the radio link is successfully established, Paired appears on the
display panel of both the receiver and the transmitter (only for SL
Handheld DW and SL Bodypack DW) and the status LEDs on the
transmitter and the receiver light up green.
If no radio link was successfully established, Pairing failed appears on
the display panel of both the receiver and the transmitter (only for
SL Handheld DW and SL Bodypack DW) and the status LEDs on
the transmitter and the receiver light up red.
If you try to pair devices that are running incompatible firmware
versions, a message appears on the display panel prompting you to
update the firmware of the transmitter.
Wenn If you update the firmware now, the transmitter and the
receiver will be paired afterwards
If you do not update the firmware, the transmitter and the receiver
will not be paired and FW mismatch appears on the display panel
of the receiver.
We recommend updating the receiver firmware first and then the
transmitter firmware.
When updating the firmware, make sure that only the transmitter
whose firmware is currently being updated is switched on. All other
transmitters should be switched off.
187
To Next Page
Loading...
