| 4 - Instruction manual
▷ Long-press the PAIR button of the corresponding transmitter until its status LED
flashes alternately green and red.
➥ The Press pair on receiver message appears on the display panel of the
transmitter (SL Handheld DW and SL Bodypack DW only).
Once the radio link is successfully established, Paired appears on the
display panel of the transmitter (only for SL Handheld DW and
SL Bodypack DW) and the status LEDs of the transmitter and the
receiving channel light up green.
If no radio link was successfully established, Pairing failed appears on
the display panel of the transmitter (only for SL Handheld DW and
SL Bodypack DW) and the status LEDs of the transmitter and the
receiving channel light up red.
If you try to pair devices that are running incompatible firmware
versions, a message appears in the Control Cockpit prompting you
to update the firmware of the transmitter.
If you update the firmware now, the transmitter and the receiving
channel will be paired afterwards.
If you do not update the firmware, the transmitter and the receiving
channel will not be paired.
We recommend updating the receiver firmware first and then the
transmitter firmware.
When updating the firmware, make sure that only the transmitter
whose firmware is currently being updated is switched on. All other
transmitters should be switched off.
189
To Next Page
Loading...
