| 4 - Instruction manual
➥ The display of the radio signal level is continuously updated.
▷ Click Stop to end the walk test.
If the result of the walk test is not satisfying, you can take the following remedial measures:
• If possible, position the receiver so that there is always a direct line of sight between
the receiver and the paired transmitter.
• If possible, remove obstacles between the transmitter and the receiver.
• If necessary, adjust the manually selected transmission power in the Control Cockpit
under RF power mode on the RF settings tab. You can find more information under
Multi-room mode.
191
To Next Page
Loading...
