Sharp DX-C310

2-53
COPIER
Contents
3
Select the erase settings.
● When [Erase] is selected
(1) Select the [Erase] key.
(2) Set the erasure width.
Select either of the keys with the keys and
press the [OK] key repeatedly to change the number.
0" to 1" (0 mm to 20 mm) can be entered.
(3) Select the [Basic Menu] key.
You will return to the base screen of copy mode.
● When [Side Erase] is selected
(1) Select the [Side Erase] key.
(2) Set the sides to be erased
Select the checkboxes of the sides that you wish to
erase.
(3) Select the [Erase Position for Original Side 2]
key.
(4) Set the erase edge on the reverse side.
When performing 1-sided to 2-sided copying or 2-sided to
2-sided copying, set the erase edge on the reverse side.
• If you select the [Same Side as Side 1] key, the edge in
the same position as on the front side will be erased.
• If you select the [Different Side from Side 1], the edge in
the position opposite to the erased edge on the front
side will be erased.
(5) Press the [BACK] key.
(6) Set the erasure width.
Select either of the keys with the keys and
press the [OK] key repeatedly to change the number.
0" to 1" (0 mm to 20 mm) can be entered.
(7) Select the [Basic Menu] key.
You will return to the base screen of copy mode.
OKBACK
(1) (2)
(3)
OKBACK
OKBACK
OKBACK
OKBACK
(5)
(6)
(7)
(4)
(2)
(3)
(1)